Only SMF (standard MIDI file) types 0 and 1 are supported. The MIDI file is re-sent when you change patches, just like the other options in the Channel Strip Inspector (such as Program Change or MIDI Clock messages). The MIDI file is sent immediately to the port selected on the external instrument channel strip. Select the Send MIDI File checkbox, then click the Select button.īrowse to the location of the MIDI file you want to add, select the file, then click Send. In the External Instrument Channel Strip Inspector, click the MIDI Output tab. Send a MIDI file using an external instrument No program change is sent until you move the knob or fader. To map the screen control without sending an immediate program change to the external instrument, choose None from the MIDI Out slot of the external instrument before you create the mapping, then choose the external instrument in the MIDI Out slot. If you are editing the program on the external instrument, your changes may be lost. Note: If the MIDI Out parameter of the external instrument channel strip is set to the external instrument when you map the screen control to the Program change parameter, a program change (Program 0) is sent when you create the mapping. By moving the hardware control assigned to the screen control, you can send program changes to the external instrument. The screen control is mapped to the Program Change parameter. In the third column from the left, select Program Change. In the Mapping browser, select the external instrument, then select the MIDI Controller folder In the Screen Control Inspector, click the Unmapped tab.
In the workspace, click the screen control you want to use to send program change messages. Send program changes to an external instrument using a screen control If you want the external instrument to respond to the program change, but do not want it to receive note or other MIDI information from your controller, click the MIDI Input tab and choose None from the Keyboard pop-up menu.
Also note that program and bank changes are sent when you edit the program change and bank change value sliders in the Channel Strip Inspector (so you can be sure that the values you enter send the correct program and bank change messages). When you select the patch, the program change and bank change messages are sent to the external instrument. Set the most-significant byte (MSB) and least-significant byte (LSB) of the bank change number using the Bank MSB and Bank LSB value sliders. If you want to send a Bank Change message, select the Send Program Change checkbox, then
0 kommentar(er)
